FLUSHED FIXTURES / CHECKED COPPER LEVELS (HOT WATER) / CHECKED CHLORINE DIOXIDE LEVELS (COLD WATER).

RAN OVERHEAD SHOWERS AND HAND HELD SHOWERS FOR 20 TO 30 MINUTES. CHECKED TEMPERATURES TO INSURE TEMPS ARE BETWEEN 85 AND 110 DEGREES. RECORDED TEMPERATURES.



Note: Water samples to determine the amount of added copper in your water using your LaMotte field copper test kit (ppm) should be taken no latter than 10 minutes after an activation cycle to receive an accurate reading. Copper test results are intended to monitor the controller activation activity. The recommended time of water sampling is early morning after an activation cycle yet before a facility begins to use higher water loads. Please consult a CSI advisor should you have any questions on water sampling for copper results. Users are responsible to properly monitor and maintain both the ionization chamber cell(s) and controllers at all times. Batch data logging after 30 days Portal-Hub.com account inactivity is not permitted.


01/08/2019
UNCLAIMED FUNDS CLAIM NUMBER:
40835459





COVERING BOILER HOUSE - JOHN R. OUT FOR SURGERY. (PARTIAL DAY COVERAGE)